Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

Zeftronics Volt Reg R15V00-A

https://www-old.roctexo.com/web/image/product.template/79202/image_1920?unique=1a80a50
Part numbers : RX1-07-00628 , R15V00-A , ASS-07-00628 , 07-00628
Unit of Measure: EA

521.03 EUR / EA 521.03 EUR 521.03 € excl. VAT

521.03 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 12 EA ready to ship on Thursday 2026-11-12
Order before 16:00 CET Today
Up to 15 EA ready to ship on Monday 2026-11-16
Order before 16:00 CET Today
29 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The Zeftronics R15V00-A, also identified by Zeftronics as the R15V00 Rev A, is a 14 V alternator controller unit combining voltage regulation with an integrated over-voltage sensor.

Designed to control alternator field current through remote voltage sensing, the unit helps maintain system voltage while providing protective and diagnostic functions for the charging system.

  • Voltage regulation: 14.2 V ± 0.2 V
  • Maximum field current: 5 A
  • Over-voltage protection threshold: 16.0 V ± 0.4 V
  • Integrated over-voltage sensing and protection
  • Remote voltage sensing
  • Low-voltage/over-voltage warning-light output
  • Field-to-ground fault protection
  • On-unit troubleshooting light (TSL)

Manufacturer reference replacement part numbers include Cessna C611001-0201, C611001-0101 and C611001-0102; Beech 33-380010; Electrodelta VR600 and VR600A; PFT DGR 6; and Ford D4FF-10316-BA/CA. Verify the applicable aircraft configuration, installation instructions and approved data before installation.

Manufacturer part number: R15V00-A.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.