Skip to Content
  1. All Products
  2. All Products
  3. xCruze 100 3 Round Glasair III
Select currency EUR
xCruze 100 3 Round Glasair III

Image for illustration only. It may show a product series rather than the exact product offered.

xCruze 100 3 Round Glasair III

https://www-old.roctexo.com/web/image/product.template/76750/image_1920?unique=8ef9bbe
Part numbers : RX1-11-18096 , XC100-047 , 11-18096
Unit of Measure: EA

3484.55 EUR / EA 3484.55 EUR 3,484.55 € excl. VAT

3484.55 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The BendixKing xCruze 100 is a digital autopilot system supplied in a 3-inch round-format configuration for Glasair III aircraft. Manufacturer part number: XC100-047.

Designed for experimental-aircraft cockpits, the xCruze 100 provides core autopilot functions including track select, GPS navigation and GPS steering modes, altitude hold, vertical-speed selection, altitude pre-select, altitude select, vertical GPS steering, and control-wheel steering. BendixKing also identifies built-in ground-track DG functionality and pitch-trim annunciation/automatic pitch trim among the standard xCruze 100 features.

The 3-inch round unit is approximately 83 mm high × 83 mm wide × 140 mm deep. The system is available in 12–28 V variants; verify the exact configuration and installation requirements against the applicable current installation and operating documentation before installation.

  • Product: xCruze 100 3 Round Glasair III
  • Manufacturer: BendixKing
  • Manufacturer part number: XC100-047
  • Roctexo part number: RX1-11-18096
  • Unit of measure: Each
Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.