Skip to Content
  1. All Products
  2. All Products
  3. Wing Tip COMMAnt Rt Model 1A
Select currency EUR
Wing Tip COMMAnt Rt Model 1A

Image for illustration only. It may show a product series rather than the exact product offered.

Wing Tip COMMAnt Rt Model 1A

https://www-old.roctexo.com/web/image/product.template/9362/image_1920?unique=9e6c4ec
Part numbers : RX1-11-21016-2 , SA-001A-2 , ASS-11-21016-2 , 11-21016-2
Unit of Measure: EA

182.29 EUR / EA 182.29 EUR 182.29 € excl. VAT

182.29 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
3 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The SA-001A-2 is the right-hand version of the Model 1A internal wing-tip VHF COM antenna. It is intended for installation inside a dielectric wing tip on a conductive-aircraft installation, providing an internal antenna arrangement without an external whip antenna.

The SA-001A design is specified for vertically polarised VHF COM operation from 118 to 136 MHz. Installation documentation states a typical VSWR of less than 2:1 across this range; final performance may vary with the installation.

  • Manufacturer part number: SA-001A-2
  • Configuration: right-hand Model 1A wing-tip COM antenna
  • Installation location: internal dielectric/plastic wing tip
  • Minimum wing-tip internal space stated in the installation instructions: 279 mm deep by 610 mm long
  • Installation should use the available wing-tip height to support vertical polarisation.

Please consult the applicable installation instructions and confirm physical fit, antenna orientation and aircraft installation requirements before installation.

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.