Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

TCW Safety Trim Servo Booster - 10 Amp - 24 Volt

https://www-old.roctexo.com/web/image/product.template/85599/image_1920?unique=8ef9bbe
Part numbers : RX1-11-19272 , ST-1-24V-10A-BSTR , 11-19272
Unit of Measure: EA

394.26 EUR / EA 394.26 EUR 394.26 € excl. VAT

394.26 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The TCW Safety-Trim Servo Booster, part number ST-1-24V-10A-BSTR, is a single-axis electronic trim-servo controller for 24 V DC systems. It is designed to receive trim commands from a compatible autopilot system or a traditional DPDT rocker switch and drive DC electric trim motors or linear actuators requiring up to 10 A rated current.

The controller uses PWM output that follows the autopilot signal and incorporates time-limited trim operation intended to reduce the possibility of trim run-away conditions. It is short-circuit protected and reverse-polarity protected.

  • Manufacturer part number: ST-1-24V-10A-BSTR
  • Input voltage: 20–30 V DC
  • Output: PWM, following autopilot signals
  • Maximum output current: 10 A DC motor drive
  • Input: direct autopilot connection
  • Single-axis configuration
  • For Experimental aircraft only; not EASA/FAA approved

Please review the applicable installation instructions and verify electrical-system, actuator and autopilot-interface suitability before installation.

Manufacturer documentation: Safety-Trim Servo Booster Installation Instructions.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.