Skip to Content
  1. All Products
  2. All Products
  3. RAMI AV-3 COMMAntenna Non-TSO
Select currency EUR
RAMI AV-3 COMMAntenna Non-TSO

Image for illustration only. It may show a product series rather than the exact product offered.

RAMI AV-3 COMMAntenna Non-TSO

https://www-old.roctexo.com/web/image/product.template/73832/image_1920?unique=8ef9bbe
Part numbers : RX1-11-05844 , AV-3 , 11-05844
Unit of Measure: EA

210.38 EUR / EA 210.38 EUR 210.38 € excl. VAT

210.38 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The RAMI AV-3 is a low-profile, snap-in mount quarter-wave antenna for ground-vehicle VHF communications. Manufacturer part number: AV-3.

Designed for field adjustment, the radiator whip may be cut to the required length for the intended operating frequency. The antenna uses a solderless cable connection at the antenna and is supplied with approximately 5.2 m of cable terminated with a PL-259 male connector.

  • Application: ground-vehicle VHF communications
  • Frequency range: 108–512 MHz, field tunable
  • Nominal impedance: 50 Ohm
  • Maximum VSWR at resonance: 1.5:1
  • Polarisation: vertical
  • Radiation pattern: omnidirectional
  • RF power capacity: 100 W
  • Maximum adjustable height: approximately 70 cm

This is a Non-TSO antenna and is not EASA/FAA approved. Confirm suitability, frequency tuning and installation requirements for the intended vehicle and radio installation before use.

Manufacturer documentation: RAMI AV-3 installation instructions.

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.