Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

MS28034-3 Engine Temperature Sensor

https://www-old.roctexo.com/web/image/product.template/126243/image_1920?unique=8ef9bbe
Part numbers : RX1-10-01668 , MS28034-3 , 10-01668
Unit of Measure: EA

1729.24 EUR / EA 1729.24 EUR 1,729.24 € excl. VAT

1729.24 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 6 EA ready to ship on Thursday 2026-11-12
Order before 16:00 CET Today
Up to 10 EA ready to ship on Monday 2026-11-16
Order before 16:00 CET Today
34 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The MS28034-3 is a thread-mounted, two-wire engine temperature sensor for temperature-measurement installations where this exact part number is specified by the applicable maintenance or equipment documentation.

It features a single sensing element, hermetically sealed tip-welded construction, integral connector and low stem conduction design. The housing and connector shell are stainless steel, with a FAS-TIP sensing element.

  • Manufacturer part number: MS28034-3
  • Two-wire element with integral connector
  • Thread-mounted, corrosion-resistant construction
  • Typical response time: 1.3 seconds (63.2% of step)
  • Operating temperature range: -70 °C to +300 °C
  • Operating pressure: 200 psi (approximately 13.8 bar); burst pressure: greater than 600 psi (approximately 41 bar)
  • Insulation resistance: 1,000 MΩ at 100 VDC
  • Resistance-versus-temperature data referenced to MIL-T-7990B, Table I
  • Typical weight: 68 g

Please verify the required part number, electrical characteristics, mounting interface and applicable approved technical data before installation.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.