Skip to Content
  1. All Products
  2. All Products
  3. McFarlane Mc6250Ll084 Push Control 7 MC6250-LL084
Select currency EUR
McFarlane Mc6250Ll084 Push Control 7 MC6250-LL084

Image for illustration only. It may show a product series rather than the exact product offered.

McFarlane Mc6250Ll084 Push Control 7 MC6250-LL084

This is a special order item. Additional fees may apply. Please contact us for details.
https://www-old.roctexo.com/web/image/product.template/103804/image_1920?unique=f0e73f1
Part numbers : RX1-05-04518 , MC6250-LL084 , 05-04518
Unit of Measure: EA

137.07 EUR / EA 137.07 EUR 137.07 € excl. VAT

137.07 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The McFarlane MC6250-LL084 is a universal push-to-unlock control from the MC6250 series. It has a blue powder-coated aluminium round knob, a 10-32 threaded push-rod end and a nominal control length of 2.1 m (7 ft).

  • Manufacturer part number: MC6250-LL084
  • MC6250 push-to-unlock control
  • 10-32 threaded push-rod end
  • Teflon-lined wound conduit with stainless-steel inner wire
  • Maximum travel: 76 mm
  • Minimum locking force: 15 lbf (approximately 67 N)

This universal control is not approved for installation on EASA- or FAA-certified aircraft and must not be used for flight controls or flight-control trim tabs. Confirm the installation requirements, control geometry and applicable airworthiness basis before use.

Manufacturer technical drawing: McFarlane Push-to-Unlock Controls (PDF)

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.