Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

JPI EDM 900 4C Experimental Engine Monitor System Package 2 Tank EDM-900-4CP-2

https://www-old.roctexo.com/web/image/product.template/26841/image_1920?unique=4a08b06
Part numbers : RX1-10-05227 , EDM-900-4CP-2 , 10-05227
Unit of Measure: EA

5621.55 EUR / EA 5621.55 EUR 5,621.55 € excl. VAT

5621.55 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The J.P. Instruments EDM-900-4CP-2 is an all-in-one engine monitoring system package configured for experimental aircraft with a four-cylinder engine and two fuel tanks. It combines a bright VGA engine display with fuel-level monitoring and a range of engine, electrical and fuel-management indications.

This experimental version is not EASA/FAA approved. Suitability, installation configuration and required aircraft-specific settings should be verified by a qualified installer before fitment.

  • Manufacturer part number: EDM-900-4CP-2
  • Configuration: four-cylinder engine; two fuel tanks
  • All-in-one EDM-900 display format
  • Monitoring functions may include EGT, CHT, oil temperature and pressure, manifold pressure, RPM, outside-air temperature, voltage, current/load, fuel flow, fuel used, endurance and fuel quantity.
  • Package information identifies a pre-wired harness, EGT/CHT probes, oil pressure transducer, oil-temperature sensor, outside-air-temperature sensor, RPM sensor, manifold-pressure transducer, current shunt, fuel-flow transducer and data-storage device.

Refer to J.P. Instruments EDM-900 installation, pilot-guide and configuration documentation for installation requirements, probe selection, operating limitations and system setup.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.