Skip to Content
  1. All Products
  2. All Products
  3. Eaton AE246-8 Hose
Select currency EUR
Eaton AE246-8 Hose

Image for illustration only. It may show a product series rather than the exact product offered.

Eaton AE246-8 Hose

https://www-old.roctexo.com/web/image/product.template/97336/image_1920?unique=5e73226
Part numbers : RX1-AE246-8 , AE246-8 , AE246-8
Unit of Measure: FT

44.12 EUR / FT 44.12 EUR 44.12 € excl. VAT

44.12 EUR / FT excl. VAT

Not Available For Sale

This combination does not exist.

Availability
30 FT available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

Eaton AE246-8 is a dash size -8 high-pressure PTFE bulk hose from the Aeroquip AE246 series. It is intended for the fabrication of hydraulic and pneumatic hose assemblies in accordance with applicable approved maintenance or engineering data.

The hose has an extruded PTFE inner tube with corrosion-resistant steel wire-braid reinforcement. Eaton describes the AE246 series as a flexible hose solution for systems subject to motion and vibration.

  • Manufacturer: Eaton
  • Manufacturer part number: AE246-8
  • Roctexo part number: RX1-AE246-8
  • Hose size: -8
  • Tube outside diameter: 12.7 mm
  • Nominal operating pressure: 207 bar (3,000 psi)
  • Minimum bend radius: approximately 73 mm
  • Construction: PTFE inner tube with corrosion-resistant steel wire braid
  • Reference standard: Eaton documentation states conformance with the requirements of AS1339
  • Unit of measure: foot

Select hose length, fittings, assembly method and installation configuration in accordance with the applicable technical data and approved procedures.

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.