Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

Bogert Cable Piper PA23-250

https://www-old.roctexo.com/web/image/product.template/101152/image_1920?unique=b0cef7c
Part numbers : RX1-11-15110 , 03M-KIT-PA-23-250 , 11-15110
Unit of Measure: EA

1509.82 EUR / EA 1509.82 EUR 1,509.82 € excl. VAT

1509.82 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

Bogert Aviation Low-Loss Copper Cable Kit for Piper PA-23-250 aircraft, manufacturer part number 03M-KIT-PA-23-250.

This aircraft-specific battery and starter cable kit is supplied with flexible 1-gauge copper cable, slim-head terminals and heat-shrink insulation. Bogert Aviation states that the cable assemblies are cut to length and supplied ready for installation.

  • For Piper PA-23-250 aircraft, serial numbers 27-2000 through 27-2504
  • Manufacturer part number: 03M-KIT-PA-23-250
  • Flexible 1-gauge copper cable with slim-head terminals
  • Heat-shrink insulated cable assemblies
  • Manufacturer states instructions, schematic diagram, sample logbook entry, STC and Approved Model List documentation are included
  • FAA/PMA approved under STC SA3531NM, according to the manufacturer

Bogert Aviation describes its copper cable kits as intended to reduce voltage drop between the battery and starter and support improved starting-system performance. Verify aircraft serial-number applicability, installed starter configuration and applicable approval requirements before installation. EASA approval or acceptance is not stated here and must be confirmed by the installer or operator.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.