Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

B&C Alternator Spline Driven Short 20-30 Amp BC425-H with SB1B-14 14V - for Homebuilt

https://www-old.roctexo.com/web/image/product.template/288237/image_1920?unique=834453b
Part numbers : RX1-07-27281 , BC425-H-SB1B-14 , BC425-H_SB1B-14 , 07-27281
Unit of Measure: EA

1517.99 EUR / EA 1517.99 EUR 1,517.99 € excl. VAT

1517.99 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The B&C BC425-H-SB1B-14 is a 14 V spline-driven alternator system configured with the SB1B-14 standby alternator controller for experimental/homebuilt aircraft electrical systems.

The BC425-H mounts on a standard AND20000 vacuum-pump accessory pad and is externally regulated. B&C specifies a rated output of 20–40 A at cruise RPM. Its design incorporates sealed heavy-duty ball bearings, dual cooling fans, a dynamically balanced rotor and a shear section in the drive coupling.

  • Manufacturer part number: BC425-H-SB1B-14
  • 14 V configuration with SB1B-14 standby controller selection
  • Spline-driven, short-format BC425-H alternator
  • Standard AND20000 accessory-pad mounting arrangement
  • Rated output: 20–40 A at cruise RPM
  • Externally regulated electrical-system design
  • For experimental/homebuilt aircraft only; not EASA/FAA approved

Installation and electrical-system configuration should be determined against the applicable B&C documentation and the aircraft’s approved or experimental build records. B&C identifies its BC425-H product resources with outline drawing, installation instructions and instructions for continued airworthiness.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.