Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

B&C Alternator - 40 Amp - Homebuilt - SF401

https://www-old.roctexo.com/web/image/product.template/293591/image_1920?unique=8ef9bbe
Part numbers : RX1-07-27358 , SF401 , 07-27358
Unit of Measure: EA

558.50 EUR / EA 558.5 EUR 558.50 € excl. VAT

558.50 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
2 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The B&C SilverFlite SF401 is a compact 40 A belt-drive alternator intended for experimental and homebuilt aircraft applications. It provides 40 A output at cruise RPM and incorporates integral voltage regulation together with B&C Dynamic Over-Voltage Protection.

Designed to simplify installation, the SF401 uses a two-wire connection arrangement for alternator output and control/enable circuits. It features sealed ball bearings, rotor balance and three integrated mounting attachment points for stable installation.

  • Manufacturer part number: SF401
  • 40 A output at cruise RPM
  • Integral voltage regulation and Dynamic Over-Voltage Protection
  • Approximate weight: 2.77 kg
  • Supplied with mounting bracket, pre-wired field connector assembly, belt tension arm, high-performance belt and attachment hardware

The supplied product information identifies the SF401 for homebuilt aircraft with 14 V electrical systems and Boss-mount engine cases. Verify suitability, installation configuration and required circuit protection against the applicable aircraft and engine documentation before installation.

For experimental aircraft only; not EASA/FAA approved.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.