Skip to Content
  1. All Products
  2. All Products
  3. A-750 Control 120 Red Knob
Select currency EUR
A-750 Control 120 Red Knob

Image for illustration only. It may show a product series rather than the exact product offered.

A-750 Control 120 Red Knob

https://www-old.roctexo.com/web/image/product.template/129908/image_1920?unique=d9cef1d
Part numbers : RX1-05-27409 , A-750-20-1200 , 05-27409
Unit of Measure: EA

190.59 EUR / EA 190.59 EUR 190.59 € excl. VAT

190.59 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The A-750 Control 120 is a vernier control assembly with a red FAA-style knob, supplied under manufacturer part number A-750-20-1200.

The A-750 series uses a 10-32 threaded shaft for a ball-point or threaded terminal. Its ball-socket construction allows the threaded end to swivel up to 80° in any direction, supporting flexible control-cable routing. A low-friction, heat-resistant inner liner is intended for use in higher-temperature areas, including engine-compartment installations.

  • Vernier control with red knob
  • Manufacturer part number: A-750-20-1200
  • 10-32 threaded shaft
  • Threaded-end swivel capability: up to 80°
  • Control travel: approximately 86 mm
  • Panel installation hole: approximately 19 mm
  • Outer housing diameter: approximately 6 mm
  • Supplied as one each (EA)

Approval status: This A-750 control is intended for experimental aircraft use and is not EASA/FAA approved. Verify suitability, installation requirements and applicable airworthiness requirements with the aircraft documentation and a qualified maintenance professional before installation.

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.